Le fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d interférences et (2) cet appareil doit accepter toute interférence, y compris celles susceptibles de provoquer un fonctionnement non souhaité de l appareil. Cet appareil est conforme aux norms CNR exemptes de licence d Industrie Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2)This device must accept any interference, including interference that may cause undesired operation of the device. Canadian Compliance Statement This device complies with Industry Canada license-exempt RSS standard(s). To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. The required antenna impedance is 50 ohms. Antennas not included in this list or having a gain greater than 3 dbi are strictly prohibited for use with this device. This device has been designed to operate with the antennas listed below which have a maximum gain of 3 dbi. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. SAR measurements are based on a 5mm spacing from the body and that compliance is achieved at that distance.Ĥ CE Mark Warning This is a class B product. This equipment has been SAR-evaluated for use in hand. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End users must follow the specific operating instructions for satisfying RF exposure compliance. FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Such modifications could void the user s authority to operate the equipment.
#TP LINK TL WN7200ND DRIVER WINDOWS 10 TV#
Note: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Any changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. 2) This device must accept any interference received, including interference that may cause undesired operation. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. This device complies with part 15 of the FCC Rules. Consult the dealer or an experienced radio/ TV technician for help. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Increase the separation between the equipment and receiver.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. All rights reserved.ģ FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Copyright 2013 TP-LINK TECHNOLOGIES CO., LTD.
No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders.
is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. 2 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice.
0 kommentar(er)
